bladeRF> help set
Usage: set <parameter> <arguments>
The set command takes a parameter and an arbitrary number of arguments
for that particular parameter. In general, set <parameter> will
display more help for that parameter.
Common parameters:
Parameter Description
-------------- --------------------------------------------------------
bandwidth Bandwidth settings
frequency Frequency settings
agc Automatic gain control
loopback Loopback settings
rx_mux FPGA RX FIFO input mux mode
gain Gain settings
samplerate Samplerate settings
trimdac VCTCXO Trim DAC settings
tuning_mode Tuning mode settings
BladeRF1-only parameters:
Parameter Description
-------------- --------------------------------------------------------
gpio FX3 <-> FPGA GPIO state
lnagain RX LNA gain, in dB. Values: 0, 3, 6 (deprecated)
rxvga1 RXVGA1 gain, in dB. Range: [5, 30] (deprecated)
rxvga2 RXVGA2 gain, in dB. Range: [0, 30] (deprecated)
txvga1 TXVGA1 gain, in dB. Range: [-35, -4] (deprecated)
txvga2 TXVGA2 gain, in dB. Range: [0, 25] (deprecated)
sampling External or internal sampling mode
smb_mode SMB clock port mode of operation
vctcxo_tamer VCTCXO tamer mode. Options: Disabled, 1PPS, 10MHz
xb_gpio Expansion board GPIO values
xb_gpio_dir Expansion board GPIO direction (1=output, 0=input)
BladeRF2-only parameters:
Parameter Description
-------------- --------------------------------------------------------
clock_sel System clock selection
clock_out Clock output selection
rssi Received signal strength indication
clock_ref Enables (1) or disables (0) the ADF4002 chip
refin_freq ADF4002 reference clock frequency
biastee Enables or disables the bias tee on a given channel
filter RFIC FIR filter selection
Ну тогда да, запустить от имени администратора видимо